Retro Mechanical Labs 432K Rev2 Distortion, Aluminum/Standard Meter

The 432k Distortion box is all about signal routing. One distortion circuit with an active hybrid diode/transistor ladder filter (with resonant feedback) for tone control. Another with a clean pass signal. Both signals are merged together and “glued” through a transistor drive and op amp style fuzz. Also equipped with CV in for filter control.

• Hyper Fuzz tone
• Hybrid Diode/Transistor ladder filter.
• Enhanced resonant feedback for more expressive tones
• Clean pass lets you bring a quality signal back into the compressed distortion
• Op Amp style fuzz at end of signal chain. Dial in harsh tones and smooth them out.
• Great for guitars and keyboards
• CV filter control. Use CV in to control filter with modular gear, synth or CV pedal.
• Low cut toggle for guitar use.
• True Bypass

Requires a regulated 18volt DC Supply. Standard negative tip with a min of 150ma. (not included) Will run on 12volts for a dirtier sound. Lower voltage will affect the smoothness of the filter.

• Distortion: Volume of Distortion
• Filter: Filter Frequency
• Resonance: Active resonant feedback
• Clean: Clean signal
• Low Cut: low end roll off
• Transistor: Transistor gain/drive
• Op Amp: Op Amp Fuzz
• Feedback: Noise loop (works best with sequenced sounds)
• Output: Volume